--------------------------------------------------------------------------------------------------------------------
			April 20, 1978
HP-1175							Bulletin
No:
AC Power Supply						HP-1175-1

	Use of the HP-1175 and the HW-202/HW-2036 and HA-202
	                                       Combination

A number of HP-1175 Power Supplies have been shipped with connectors that
are not compatible with the above combination.

To power the combination from the HP-1175, do the following:

	Remove the present connector [if any] from the gray cable on the
	 HP-1175.  Strip the wires and connect a female connector [PN
432-73]
	 to each of the two wires.  The wires will be a tight fit into
these
	connectors.  Then pust these connectors into connector housing
	[PN 432-723];  This connector will mate to the existing female
connector
	on the HA-202.

	Connect spade lugs [PN 259-22] to one end of the DC (mobile)
cable
	furnished with the HW-202 or HW-2036.  The other end should
already
	have the male connector housing which connects to the
transceiver.

	Now connect the transceiver power cable (spade lug end) to the
	connector block on the HA-202 along with the power cable for the
	 HA-202.  Be sure to observe polarity markings.

	The transceiver and amplifier can now be powered together from
the
	HP-1175 power supply.

	This combination will not exceed the current capability of the
HP-1175.

Future production will incorporate this connector scheme.
-----------------------------------------------------------------------------------------------------------------
That's all that is listed for the HP-XXXX series (1966-89).  Enjoy.


73 de Joe  W7LPF/4  [NNN0KUU]
QWCA - SOWP - NCVA - FISTS - RCC
Gordonsville, Va 22942 [Orange Co]	
 

